Qczek RC Blog

Blejzyk Glider

Jun
22

New module installed

Apr
27

New module’s replaced old one.

The 6.2 module introduced 3db receiving sensitivity improvements and less harmonics comparing to version 1.1.

 

New version of QCZEK LRS firmware available

Apr
26

Time to release new firmware πŸ™‚

What’s new:

  • support for old and new modules (hw version 1.1 for old, and 6.2 for new one)
  • firmware compiled with -odM4 flag which disable faulty optimization
  • serial port speed can be set
  • new telemetry mode is available, you can directly connect uBlox GPS and use it.
  • new parameter timeToFS making possible to setup time to fail save activation
  • single servo mode, first channel value could be output as standard 50Hz servo PPM signal. It make possible to control single servo directly from receiver.

You can download it from download page.

RSSI checked at 5km distance

Mar
02

This is raw RSSI value report by LoRa modem, using lowest possible TX power less then 23dBm (less then 250mW), and non directional antennas.

(more…)

QCZEK LRS is working very well :)

Feb
20

Finally I found time to test it.

(more…)

Development of Qczek LRS

Feb
08

Months ago i started to develop custom firmware for cheap 1W LORA module, to use it as LRS RX/RX devices.

Now it’s almost ready for testing πŸ™‚

(more…)

Blejzyk is flying ;)

Oct
15

This is relay nice FPV glider πŸ™‚

Build log

 

LRS Moxon antenna v2 (tuned)

Oct
15

I recently bought simple sweep spectrum analyzer, and now i can measure and tune all my antennas.

Moxon antenna i made was not so good tuned as expected, so I made another one.

Now it looks much better πŸ™‚

20161015_162530

(more…)

Blejzyk FIRST – build log

Aug
16

I decided to use Blejzyk FIRST glider as my next FPV platform…

So I 3d printedΒ  some parts, instead using wooden.

1

(more…)

Li Ion batteries are not safe as you think

Jul
06

My Ranger catch fire after crash πŸ™

pozar1

(more…)