I was tested 868 mhz version during two weeks. Its work fine.
One important bug found. When PPM signal was disconnected from TX module, receiver didn’t switch in failsave mode.
Minor bug. Every 2-10 min (randomly), signal was lost for 1-2 sec (may be hardware module problem).
After often switch on \ switch off TX module (~1-2 sec on\ 1-2 sec off), stayed as brick and became very hot, without any RF signal transmitting. (may be hardware module problem). For RX module in this test no problem was found. Modules was powered thru stepdown converter (12V to 5.03V).
New 868 module will coming soon, and I will test it again.
Hi Igor,
Thanks for your feedback.
I will check reported problems and will try to fix it in next release.
What version do you use?
can you flash bricked modules again?
Krzysiek
Dear Krzysztof Kuczek
I have about 15-20 sec for flashing (qczek_lrs_hw_6.2_868_master_v1.10_BETA_P_CPPM_P_PXX.s19) STM, after that time SX chip became extremely hot, and heated the STM chip to high temperatures. It seems the SX127X chip problem. I think this is an isolated incident for CDSENET yellow 868mhz module. Soon new 868mhz module will arrived. I will test it again and will prepare full review to rc forum.
We use cookies to ensure that we give you the best experience on our website. If you continue to use this site we will assume that you are happy with it.Ok
Good day, Krzysztof Kuczek!
I was tested 868 mhz version during two weeks. Its work fine.
One important bug found. When PPM signal was disconnected from TX module, receiver didn’t switch in failsave mode.
Minor bug. Every 2-10 min (randomly), signal was lost for 1-2 sec (may be hardware module problem).
After often switch on \ switch off TX module (~1-2 sec on\ 1-2 sec off), stayed as brick and became very hot, without any RF signal transmitting. (may be hardware module problem). For RX module in this test no problem was found. Modules was powered thru stepdown converter (12V to 5.03V).
New 868 module will coming soon, and I will test it again.
Hi Igor,
Thanks for your feedback.
I will check reported problems and will try to fix it in next release.
What version do you use?
can you flash bricked modules again?
Krzysiek
PS
Maybe it will be better to ask all question there
https://www.rcgroups.com/forums/showthread.php?2837542-QCZEK-LRS-DIY-433MHz-1W-(30dBm)-LORA-RC-LINK-with-telemetry
It may be useful for community.
Thx
Dear Krzysztof Kuczek
I have about 15-20 sec for flashing (qczek_lrs_hw_6.2_868_master_v1.10_BETA_P_CPPM_P_PXX.s19) STM, after that time SX chip became extremely hot, and heated the STM chip to high temperatures. It seems the SX127X chip problem. I think this is an isolated incident for CDSENET yellow 868mhz module. Soon new 868mhz module will arrived. I will test it again and will prepare full review to rc forum.
Yes,
Maybe hardware issue, i have never experience such a problems…
Btw, please use lates (1.50) version instead of old one…
Krzysiek