Find out more in download section.
Enjoy new 2.11 version of Qczek LRS, as I did today morning :)
Category: QCZEK LRS
Building VTOL plane
It’s always fun to build something new, so I decided to convert my old Ar Wing 900. 3d printed motor mount seem to be enough to convert the plane to VTOL tail sitter. 30 Amps ESC are located close to motors, so we have a lot o place inside the fuselage. And finally first flight. […]
Qczek LRS 2 – how to
If you have any problems, try follow my guide 🙂
Tiny Wing gets HD Camera
There was time to upgrade my nano wing, so new LiIons and RunCam Split nano on board. Now it weights more (115grams) but it can record full HD video, and total distance is more then 10km. Early morning fly…
LDARC 450X – 118 gram FPV PLANE
I was wondering how small FPV plane can be build, and decided to check it. As a air frame I used LDARC 450X foam plane, which is very small, but big enough to mount FPV gear. And everything ready to flight (including 450mAh 2s lipo) weights only 118g 🙂 So, we have following stuff on […]
Pan servo for my Ar Wing 900
AR Wing 900
My new build 🙂
Mini Skywalker
This is quick info about my smallest FPV build. It’s only 394g ready to flight, but the goal is to build something below 250g.
Making QLRS lightest
This is quick guide, showing how to replace SMA connector by tiny U.FL used for 868MHz FrSky antennas, and make really small Qczek LRS RX. The hardest past of modification is SMA connector removal. I did it using hot air… Next very important thing (don’t forget about it) is removal part of RF signal trace. […]
Qczek LRS Meets Taranis X-Lite
This is quick guide how to use QLRS with Taranis X-Lite using 3d printed module case designed by me. First thing you should know, is that X-Lite does not support 9ms PXX protocol like Taranis X9D does, so you will need to use PPM output which is a little bit slower, but suitable for long […]